Belt Health Monitoring

Skip to content

Products / Belt Health Monitoring

BHM-1 · LASER + VISION + THERMAL

Catch belt damage
before it fails.

Inspect the running belt and map defects to belt position, supporting earlier maintenance decisions.

Discuss your belt inspection ↗
Reference illustration of laser, vision and IR thermal sensors inspecting a conveyor belt.
Reference illustration from the supplied product document. Final installation is project-specific.

COMPLEMENTARY INSPECTION MODES

Look at the surface. Investigate beneath it.

VISION / TRIANGULATION

Surface damage

Tears, cuts, holes, splices and gouges are detected and mapped through surface imaging.

Visible surface

THERMAL EXCITATION

Subsurface indications

Thermal inspection supports detection of indications associated with micro-cracks, delamination and corrosion.

Thermal response

Illustrative layers; these diagrams do not show actual test results. Detection suitability depends on the belt and site configuration.

From reference line to maintenance action.

Laser lineSurface reference
AcquisitionVision + IR streams
AnalysisClassification + position map
Operator insightAlerts, reports and trends

One dashboard, full belt status.

Live vision and thermal views, defect history and system status support inspection planning. Live monitoring combines vision and thermal views with belt-position mapping.

Reference configuration

Standard/reference configuration. Final values confirmed per project during the site survey.
Laser line scanner20 W; 650 nm
Vision cameraHigh-speed industrial camera; triangulation-based surface imaging
Thermal detectorIR thermal camera; thermal-excitation subsurface inspection
AnalysisAutomated detection, classification and belt-position mapping
Data transferReal-time high-speed link to control unit / local laptop
SoftwareLive views, defect log, alerts, reports and historical trends
MountingOverhead gantry; fixed span above belt centerline
EnvironmentIP65; −20°C to +55°C
CommunicationEthernet/IP, Modbus TCP, OPC-UA; protocol on request
AlertsConfigurable defect alerts and automated reporting

Final configuration confirmed per project during the site survey.

Questions about belt inspection

How are surface and subsurface indications distinguished?

Vision/triangulation inspects visible surface geometry. Thermal-excitation inspection evaluates subsurface indications; suitability is assessed for the belt and conditions.

What information supports configuration?

Conveyor length, belt type, width and speed, failure modes, inspection priorities and operating environment.

FROM DATA TO A PLANT DECISION

What the measurement makes possible.

Process benefit

Classify surface damage and subsurface indications, map belt position and track condition over time.

Operational outcome

Support earlier maintenance attention and planning that can reduce unplanned disruption. Outcomes depend on the belt and operating conditions.

APPLICATION ENGINEERING

Discuss your installation.

Share your process details to help us assess the measurement point and configuration.

This field is required.
This field is required.
This field is required.
This field is required.

FROM MEASUREMENT TO A PRACTICAL DECISION

Discuss your application
with an engineer.

Tell us about your process ↗